About this Item
- Center mount design
- (3) 5/8 in. wood beam mounting holes
- (2) 9/16 in. flat-plate hoist mounting holes
- 6061-T6 marine-grade US aluminum
- Fits wood joists up to 8 in.
- Includes dual-pipe support w/ 1/4 in. grease fittings
- 19 in. between pipe sleeves
- Fits an optional cable winder
The Flat Plate Hoist Hanger for Wood Beams is designed for dual drive pipe support. Designed to mount onto wood beams up to 8 in. (adjustable). Made from 6061-T6 marine-grade US aluminum. (3) 5/8 in. wood beam mounting holes. It Fits 1/2 in. bolts. Features (2) 9/16 in. flat-plate mounting holes that accept 1/2 in. bolt.
19-in. gap between the sleeves. Sleeves have 1/4 in. grease fittings. Allows for optional cable winder between the sleeves. Mount the boat hoist horizontally for maximum overhead clearance. Designed for easy installation on boat lifts.
Center mount design.
Wood beam mounting fasteners not included.
Dual pipe supports, with or without hoist hanger, is best used in a center mount configuration. A 4,000 lb. maximum rating per hoist hanger when used correctly in center mounting. Side mounting greatly reducts the dual pipe support and hoist hanger capacity. A 1,000 lb. maximum rating when used correctly in side mounting. See the attached guide for more information and limitations.
Center-mount pipe supports are only recommended for center mount or twin mount installations. It is not recommended to use pipe support on a side mount installation. Never attempt to straight-line lift any more than 4000 lbs on a side mount overhead lift or straight line more than 6000 lbs on center or twin mount lifts. Only use the full length of the pipe to connect both pipe supports.
Do not attempt to use two short pieces of the drive pipe. If designing or engineering your overhead lift, you must download and read the BH-USA overhead boat lift guide that can be found on this page. Also available in the tech guide section. BH-USA makes available complete engineered and rated lifts and highly encourages choosing this option over designing and engineering a boat lift on your own.
The above ratings of the dual pipe supports are only valid if installing or using the pipe supports with the BH-USA overhead boat lift guide. The Side Mount and Twin Mount ratings are based on straight line pull. Rating is based on per pipe support and not per boat lift. When considering the weight of your boat, you must use full wet weight plus the weight of the boat cradle. (wet weight + boat cradle weight = total lifting weight)
||25 1/2 in. x 24 in. x 8 5/8 in.
|Wood Beam Mounting Holes:
|Wood Beam Mounting Design:
|Wood Beam Hole Size:
|Hoist Mounting Holes:
|Hoist Hole Size:
|Maximum Beam Size:
|Between Pipe Sleeves:
||1 (per sleeve)
|Center Mout Maximum Rating:
|Side Mount Maximum Rating:
BH-USA engineers and manufactures factory-rated complete boat lifts. We highly recommend purchasing one of these boat lifts instead of building your own. If you, or your installer, buys parts and pieces to engineer your custom boat lift, it will no longer be considered a Boat Hoist USA engineered boat lift.