Elite 3/4 HP Painted 56 Frame Boat Lift Motor

15 reviews
  • TENV Housing
  • UL Listed
  • NEMA Enclosure
  • 56 Frame Mount
  • Single Phase

From$212.00

Clear Selection and Start Over

About this Item

  • TENV Housing
  • UL Listed
  • NEMA Enclosure
  • 56 Frame Mount
  • Single Phase

Elite 3/4 HP Painted 56 Frame Boat Lift Motor

The Elite 3/4 HP Painted 56 Frame Boat Lift Motor is a NEMA motor that is UL Listed and CSA approved. Totally enclosed, non-venting housing (TENV) motor helps prevent dirt and insects from getting into the motor. Standard duty, single-phase, dual voltage motor with a start capacitor. The 56 frame mount fits most standard flat-plate hoists including all BH-USA flat-plate hoists. Easy to follow wiring diagrams included. It does not work with direct drive input hoists.

Motor only wired 220 volts from the factory. Rewirable to 110 volts. Motor only does not include 2″ motor pulley, GFCI wire harness, or boat lift switch. Wired motors include the 2″ motor pulley, GFCI wire harness, boat lift switch, and cable length in the styles you select.

BH-USA recommends using a licensed electrician to wire or rewire any electrical component.

Specifications

Model #: 93197 Max Run Time: 15 Minutes
Dimensions: 8"" x 9 1/2"" x 6 1/2"" Weight: 24 lbs. (Motor Only)
Catalog #: N/A SKU: 60420
Horsepower: .75 Mounting Type: C
RPM: 1725 Service Factor: 1.0
Voltage: 115/230 Phase: 1
Amps: 10.8/5.4 SFtartA: N/A
Herz: 60 AMB: 40
Frame: 56 HSG: TENV
Code: L Insulation: B
Shaft Diameter 5/8""

Tech Guides

Reviews

15 reviews for Elite 3/4 HP Painted 56 Frame Boat Lift Motor

Rated 4.27 Out of 5

5 star
73.33%
4 star
6.67%
3 star
6.67%
2 star
0%
1 star
13.33%

  1. Tom Cason

    Motor was a quick install plug and play. I ordered a spare to use in future.
    BH-USA is great to deal with easy to order and very QUICK to ship – exceeded my expectations.
    Motor was shipped with mounting bolts and replacement key a unexpected bonus.

  2. J. Woody Kennedy

    Excellent product. Easy conversion to 110v. Very quiet

  3. We put in hundreds of lifts a year, we have never seen a better motor

    J Carpenter

  4. Kept it simple and it was easy. Rather than mix and match old wiring harness and switch, I opted for a pre-wired motor. New bolts and pulley made installation super easy. Delivery was fast. The old motor sounded like a coffee grinder. Glad I didn't wait for a motor failure. There is nothing FUN about not being able to lift your boat up or down from your boathouse.

    Riverdawg

  5. Just got it, and it works as to be expected so far. I am glad to see that it is all-enclosed, as we have a problem with dirt dobbers getting inside the motors here in Florida. Wiring was made easy with the provided booklet and diagrams. Thanks for including SS bolts BUT, I used regular mild steel bolts because SS will cause corrosion of the dis-similar mild steel it is in contact with. Four wire nuts would be a nice inclusion. Just sayin.

    Al S

  6. I purchased this motor to replace my old 3/4hp century. I wired the motor and rewired my switch exactly as shown in the included manual. went to start it up and the motor ran very poorly and was not achieving the spec rpm resulting in the lift lowering each side at different rates. The capacitor ended up blowing after just a very short time. I looked at the return policy and it seems incredibly difficult to return any product that has been opened. I would recommend looking elsewhere for a replacement motor.

    Aaron

  7. It needs gaskets every where and a cab for the electrical connection to make it as water resistant as possible because it is around water

    Dwayne J

  8. Great motor but switch was wired in reverse. This was easy to install and ready to go right out of the box. By far the most complete solution with great switch and breaker already included and fully wired.

    Howard K

  9. Moyer works great

    Michael P

  10. Motor arrived early. Included 4 stainless mounting bolts, nuts & lock washers. Also included a drive shaft keyway. Product booklet contained "detailed" wiring instructions. I would definitely purchase from this company again.

    Blount

  11. I will recommend bh-usa 100% to everybody, I was 100 % satisfy with everything

    Lazaro D N

  12. Just what I needed, and I liked that it was all wired up and ready to go.

    Albert J

  13. Works like a champ!

    Dave M

  14. Works as describe and a direct replacement

    ryc

  15. Been buying these for the last 10 years , I get about 4 to 5 years out of them due to the salt life living .One day I would like to up grade to the stainless steel but I understand the inside components are the same .

    cautowizz

Email Cart
Your Shopping Cart will be saved and you'll be given a link. You, or anyone with the link, can use it to retrieve your Cart at any time.
Back Email Cart
Your Shopping Cart will be saved with Product pictures and information, and Cart Totals. Then send it to yourself, or a friend, with a link to retrieve it at any time.
Your cart email sent successfully :)