About this Item
- C-Face Mount (Direct Drive Style)
- NEMA Enclosure
- TENV Housing
- UL Listed
The Elite 3/4 HP Direct Drive Boat Lift Motor is a NEMA motor that is UL Listed and CSA approved. Totally enclosed, non-venting housing (TENV). The housing helps prevent dirt and insects from getting into the motor. The motor is a standard duty, single-phase, dual voltage with a start capacitor. The c-face mounting style fits direct input face mounts. Fits direct drive systems like the BH-USA A-Drive Direct Drive Systems, Golden Sea Drives, and other direct drive input faces. Easy to follow wiring diagrams included with the motor. The Elite 3/4 HP Direct Drive Boat Lift Motor features colored T-Wires and each comes with a cross-reference wire chart for all Leeson Electra-Gear motors. Made by Elite Motors. It does not work on flat-plate belt-driven boat hoists.
Motor only wired 220 volts from the factory. Rewirable to 110 volts. Motor only doesn’t include GFCI wire harness or boat lift switch. Wired motors include a GFCI wire harness, a boat lift switch in the desired style of the switch, and cable length selected.
BH-USA recommends using a licensed electrician to wire or rewire any electrical components.
What is a C-Face Motor?
A “C–Face” motor is a common American mechanical standard. Designed with a rugged flange on the face of the motor for mounting purposes. The weight of the motor is supported by the flange. Most commonly attached to a gearbox. The flange is strong enough to cantilever the motor.
The NEMA C-Face mount incorporates a machined-face flange and a pilot on the end of the shaft to allow direct-coupling with equipment. Bolts pass from the mounting-face through threaded-holes in the motor.