Elite 1 HP Painted C-Face Boat Lift Motor

About this Item

Elite 1 HP Painted C-Face Boat Lift Motor

The Elite 1 HP Painted C-Face Boat Lift Motor is IP-55 NEMA rated, UL listed, and CSA approved. Designed with stainless steel housing with aluminum end-bells, double-shielded ball bearings, and dynamically balanced rotors. Features a TENV (totally enclosed, non-venting housing) motor housing. TENV prevents dirt and insects from entering the motor. The motor is a single-phase, dual voltage motor. It has a C-face mounting style. The motor fits the BH-USA A-Drive direct-drive boat hoists, Golden Sea Drives, and other brands of direct-drive hoists. Easy to follow wiring instructions. The motor has colored T-Wires. Each motor comes with a cross-reference wire chart. Made by Elite Motors. It does not work on flat-plate boat hoists.

Motor only wired 220 volts from the factory. Rewirable to 110 volts. Motor only does not include a 2″ motor pulley, GFCI wire harness, or boat lift switch. Wired motors include the 2″ motor pulley, GFCI wire harness, boat lift switch, and cable length in the styles you select.

BH-USA recommends using a licensed electrician to wire or rewire any electrical component.

What is a C-Face Motor?

A “C–Face” motor is a common American mechanical standard. Designed with a rugged flange on the face of the motor for mounting purposes. The weight of the motor is supported by the flange. Most commonly attached to a gearbox. The flange is strong enough to cantilever the motor.

The NEMA C-Face mount incorporates a machined-face flange and a pilot on the end of the shaft to allow direct-coupling with equipment. Bolts pass from the mounting-face through threaded-holes in the motor.