About this Item
- Made from cast aluminum
- Fits 1/2 in. drive belts
- 3/4 in. (.750) bore
- Warping resistant
- Belt gripping technology
- Used with flat-plate boat hoists
10″ Aluminum Die-Cast Hoist Pulley
The 10″ Aluminum Die-Cast Hoist Pulley is made from an aluminum die-casting process. Used on BH-USA Flat Plate hoists for more than 15 years. The design is much stronger in marine environments. Won’t swell or bend. Belt-gripping technology featured on the inside of the pulley helps eliminate belt slippage. Fits any known flat-plate hoists. Warping resistant. Deeper fit for drive belts. .750″ bore. Accepts up to 1/2″ drive belt. Made by BH-USA.
Worked great
Kathleen M –
Mounted on an older ACE flat plate hoist. Works great & belts it perfectly.
Blount –